Search:

I had looked at these Championman but wasn't sure it would mount to the existing mounting holes. Wanting to eliminate the need for drilling more holes in the boat.

Currently has a motorguide pro series and would like to switch over to an XI 5. Mounting is different patterns and would rather not drill more holes. Is there an adapter plate or has anyone made one...

Pick up tube was extremely tight, was afraid of breaking or stripping the threads. At this point didnt have anything to lose though but it finally gave way. 4 ft cheater and 1 1/4 wrench with lots...

Put the gas line straight into the tank and ran fine. Still runs about 3to 4 mins and dies. Bulb is flat and you can't pump it, will slowly start to receive fuel again and pump up hard. Seems to be...

I haven't tried that but definitely will before I remove anything else as it doesn't want to come apart easily. Thank you.

Not able to pull gas from the tank with the primer bulb, removed the barb fitting and don't see a check valve so I'm assuming it's been removed at some point. Hooked air nozzle to fitting and not...

I will have to check on the powder coating. Cost and color availability. Thank you for the response.

My 2 cents for what it is worth. Champion boats never sent out a boat with a bad transom that I know of. The design of the their boats and transom is very good and very well made, Probably better...

My boat trailer needs refinished and i would like it to look nice of course. What is the best paint or coating for this? What is everyone using? Pros and cons of each.

Thank you and I will have to check them out also.

Seen this system advertised and is rated for up to 300hp motors. It's less than half of a seastar system. Anyone have any experience with this. Only couple hundred dollars more than replacing the...

I will have to look into the spectrum gel. The yellow gel is the only one I've had an issue with and it was just covering. I'm not sure where I was reading but someone had recommended them to another...

I bought this gel from fgci, thought they were a quality gel company? I haven't purchased all the gel at this time but if there is a better source I would definitely look into it. I didn't thin the...

Thank you for the reply APS. I usually spray 4 coats with duratec in the last but it seems that I have bleed through from the white. It is currently a white and dark green bottom. Green is covered...

I am wanting to gel the bottom of a boat yellow that is currently white. Test patch has been hard to cover without being pretty thic .Did not check the thickness with a gage though. Any suggestions...

I understand that completely but it was listed as in stocks and the individual seals weren't so that was the reason I ordered it.

Thank you ChampionMan. Would rather have OEM but can't find them and have looked at several places on line also. Purchased an OEM lower unit kit but they have informed me now it's out of stock and no...

Found water in my gear oil and was going to replace my lower unit seals but it's a 240 day wait for the seals and complete kit is on backorder with no date given. Is there aftermarket seals for this...

Thank You very much.

Rojo when are you sanding the green masking tape with the red scotchbrite pad? Thank you for your advice and sharing your knowledge also.

Thank you, i didn't realize that all had flotorq hubs. Learning though.
'

New to Yamahas, what thrust washer will i need to run a fury or tempest prop on a hpdi 250if it doesn't have a flotorq hub ? Thank you.

Thank You for the input.

I am needing a little help, purchased an 07 HPDI 250 and was wanting information on what cables with what pins I will need to hook this motor up, The boat was running a merc before and this is my...

Thank you gentleman i have read enough. I figured someone here would have an opinion on them.