Search:

Type: Posts; User: shewstring

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    615

    Same. There haven’t been any changes on the...

    Same. There haven’t been any changes on the SmartCraft gauges. You can replace your SC1000 tach with a MercMonitor if you want more information in one gauge. As long as you have the smartcraft...
  2. Thread: Verado

    by shewstring
    Replies
    3
    Views
    505

    Blazerguy, you will need the controls and...

    Blazerguy, you will need the controls and steering as the Verado is a digital - throttle and shift as well as electro-hydraulic steering. The steering uses higher pressure (hoses) than what you have...
  3. Replies
    10
    Views
    836

    Are you going from a V8 ProXS to a V8 Verado? ...

    Are you going from a V8 ProXS to a V8 Verado? I'm doing the same on my boat as I regretted losing the power steering and silent running of the Verado series. The ProXS has a higher top RPM, 6200...
  4. Replies
    2
    Views
    317

    You will need to run the fuel sender harness from...

    You will need to run the fuel sender harness from the fuel tank to the motor. There is a boat harness plug you will connect to. The data for fuel will then be on the Smartcraft CAN Bus. The...
  5. Replies
    180
    Views
    17,235

    What do you recommend for a Ranger 2080 - similar...

    What do you recommend for a Ranger 2080 - similar to a 620? Thanks
  6. Replies
    6
    Views
    789

    What you'll need to check: -verify you have a...

    What you'll need to check:
    -verify you have a J-box under your dash for where the Mercury mercmonitor is plugged into? The J-BOX is a mercury smart craft junction box usually with 4 ports. If you...
  7. Replies
    11
    Views
    3,089

    The big difference between the two is the the...

    The big difference between the two is the the Gateway only SHOWS information on the display unit via NMEA2K whereas the VesselView Link allows you to use your display to CONTROL and SHOW information....
  8. Replies
    9
    Views
    587

    I have a HDS Live 16 on a Blazout mount. I put...

    I have a HDS Live 16 on a Blazout mount. I put aluminum backing plats behind mine. I’m using the 4” arm to keep it tucked in close to reduce the torque the thing puts on the mount. It sure is a big...
  9. I would agree with the comment, "the dealer...

    I would agree with the comment, "the dealer hooked it to the 3rd trolling motor battery". I do use the bow mount trolling motor for most of the steering duty when trolling.

    I do question and am...
  10. I have a setup similar to what you are looking at...

    I have a setup similar to what you are looking at with the factory rigging of the isolator. I have a Ranger 2080 with a 250 l6 Verado and the 15 EFI kicker. The factory will hook the isolator to...
  11. Replies
    13
    Views
    2,083

    Wow, sounds extreme for a motor with only 170...

    Wow, sounds extreme for a motor with only 170 hours. Did you buy the motor new? If used, does the sn on the pcm match what is stamped on the block?
  12. Replies
    13
    Views
    2,083

    Bummer...keep us posted on what they find.

    Bummer...keep us posted on what they find.
  13. Replies
    13
    Views
    2,083

    I think you may be on the right track with a weak...

    I think you may be on the right track with a weak battery. Check and clean all connections and have the battery load tested. Batteries Plus will do it.
  14. Replies
    34
    Views
    8,167

    You're good, your serial number is after 2B588807.

    You're good, your serial number is after 2B588807.
  15. Replies
    3
    Views
    525

    Agree with fishin couillon. Merc sells a NMEA2K...

    Agree with fishin couillon. Merc sells a NMEA2K gateway, but for around the same money, you can get the MercMonitor lvl1 with a gateway pigtail on it. If you have a digital control motor (DTS), I...
  16. Replies
    0
    Views
    501

    Raymarine Axiom 12 RV

    For those interested in a nice X-mas treat, I have an excellent 1 year old Axiom 12 RV posted on the Swap board.

    http://www.bbcboards.net/showthread.php?t=946964
  17. Replies
    41
    Views
    7,325

    Thank You chocolatemoose

    Thank You chocolatemoose
  18. Replies
    41
    Views
    7,325

    Will the new hypervision hv-100 transducer work...

    Will the new hypervision hv-100 transducer work on the axioms as well?
  19. Replies
    31
    Views
    4,244

    SliverFox579, PM me and I will share my setup...

    SliverFox579,
    PM me and I will share my setup with you and how I have it hooked up. I have a MercMonitor LVL3 with the NMEA2K Gateway. All data available on the SmartCraft system is available for...
  20. Agree with MichaelJ3 on the fact that if your...

    Agree with MichaelJ3 on the fact that if your nema2k network has an issue or chart plotter, you have no gauges. The VesselView 5, 7, 9 and VesselView Link with a Simrad, Lowrance, or B&G chart...
  21. Replies
    7
    Views
    2,778

    Great pictures. Target separation is great.

    Great pictures. Target separation is great.
  22. Replies
    16
    Views
    11,663

    Sticky: Happy to see Raymarine responded to my...

    Happy to see Raymarine responded to my ask...feature is now present in 3.5.40 Awesome!!!
  23. Thread: Smartcraft?

    by shewstring
    Replies
    2
    Views
    388

    Yes, both the V6 and V8 models.

    Yes, both the V6 and V8 models.
  24. Replies
    9
    Views
    2,479

    Bamaman, Very true that there is more left in a...

    Bamaman,
    Very true that there is more left in a 225, but if Mercury did that, a lot of boats couldn't be sold to run it with their coast guard plates stating 225HP, 250HP, or 275HP max. Also, what...
  25. Replies
    16
    Views
    11,663

    Sticky: Excellent thread...I would like to see the...

    Excellent thread...I would like to see the Fishing Range selection on the Chart application be selectable by 1' increments vs. 10'.
Results 1 to 25 of 41
Page 1 of 2 1 2