Why don't you want to rebuild it? They are simple to rebuild and much cheaper than a entire fuel pump. I always get to long bolts to assemble the pump parts on. this keeps everything aligned. ...
Type: Posts; User: straffordengineer
Why don't you want to rebuild it? They are simple to rebuild and much cheaper than a entire fuel pump. I always get to long bolts to assemble the pump parts on. this keeps everything aligned. ...
I removed my MDI transducer from my Ultrex since I needed a Garmin transducer instead of a Hummingbird transducer. It was not that difficult. I don't know why Minn Kota says it can't be done. I...
I had an Ultrex with a MDI transducer as well and had no room to mount an external transducer. I simply replaced the nose cone (with the built-in MDI) with a plain nose cone from a Terrova. I had...
I have had my 93sv fall out of the cradle before. It is mounted to the right of my steering wheel. I caught it just as it fell out and was heading for the water. Turns out I was not fully seating...
I have a Garmin 106sv networked with a Garmin 93sv. The 106 is at the bow and the 93 is at the steering wheel. When using the fishing chart on the 93sv by itself, the chart works great. When I use...
I agree but the Carlisles were almost half the cost of the Endurance. I figure it was better to buy 2 sets of normal priced tires instead of one set of very high priced tires. Based on the amount of...
Every Ultrex, Fourtrex, Terrova, and Ulterra schematic I looked at shows the bearing, a thrust washer, and 2 Bellville washers. The thrust washer is part number 990-045 and the Bellville washers are...
wire could range from #8 to #2 depending on the motor thrust rating and the distance between the batteries and the trolling motor.
Mike, I also identified just a plain nose cone without a transducer for a 4" motor Terrova (421-276). The illustrated parts list indicates a 9421-287 or a 421-276 fit the 4" Terrova so since the...
Thanks, these videos were very helpful.
you can’t buy the Hummingbird transducer nose cones separately but you can buy the standard US2 nose cone. $87.
I received a response back from Transducer Shield and Saver. It doesn't sound like anything I am interested in. The complete set-up will cost almost $200. $110 for the Garmin transducer bracket...
I have the MDI transducer. I looked on the site you mentioned. I did not see what you are talking about. There is only about 3 inches of clearance behind the MDI transmitter. I don' see how it...
Don't buy Goodyear Marathon. I have had 3 sets go bad within 3 years and I only drive about 1200 miles per year. Same problem happened on all 3 sets. The belts shifted internally and made the tire...
I have driven Chevy's for 45 years now and I would recommend a FORD. You couldn't get me one of the new Chevy's with Active Fuel management. The Chevy's might get a little more mpg but if you plan...
I have a 2020 Ultrex that came with a built-in Hummingbird MEGA transducer. I bought the trolling motor used (like new) for $1400 so I couldn't be picky about the transducer. Unfortunately, I don't...
For slight bends, I have used blocks of wood and a C clamp. You need to bend the skeg past straight or it will go right back to the original position. the key is not to get too aggressive. Bend it...
What do you mean by "reversed" a cell or two. I don't see how a discharging a battery can reverse a cell.
My Minn Kota Edge trolling motor is acting up. It has a know to control the speeds. It is a 5 speed. Speeds 3, 4, and 5 work fine. However, Speeds 1 and 2 operate at full speed. What could be...
The only reason that would cause the linkage rod to flex is the carb is binding up and not rotating. You indicated that the carb will open 100% if you open it manually. Therefore, I don't think you...
what kind of problem are you having with WOT?
I have a 2004 Silverado with a 4 speed tranny and a 5.3 engine. I love the truck but I hate towing my boat with it. If I keep the cruise OFF, it will do fine and I get about 13 mpg. If I leave the...
I am not satisfied with the built-in transducer in my Motor Guide Xi3. I know I can always strap my original Lowrance transducer (which works so much better) to the outside of the Xi3 shaft but I...
I didn't see where you changed the fuel pump diaphragm. You are either losing spark or fuel when you get to higher rpms. Don't know why it isn't starting right now. You need to determine if you...
I am wanting to purchase a GPS trolling motor. I don't want to spend an arm and a leg but I want one that will work well. I am mainly just wanting the Anchor (spot lock) feature. Based on my...