Search:

Type: Posts; User: mikeno

Search: Search took 0.00 seconds.

  1. Replies
    252
    Views
    90,654

    Sticky: Mike Nault Lees Summit Lake of the Ozarks,...

    Mike Nault
    Lees Summit
    Lake of the Ozarks, Truman, Table Rock
  2. Replies
    9
    Views
    534

    Per the Mercury service manual: "WARNING HORN...

    Per the Mercury service manual:
    "WARNING HORN SYSTEM CHECK

    Turn ignition key switch to "Run" position.

    Warning horn will BEEP once....
  3. Replies
    9
    Views
    534

    2001 90hp ELPTO SN1090412YD

    2001 90hp ELPTO SN1090412YD
  4. Replies
    9
    Views
    534

    Right - it isn’t.

    Right - it isn’t.
  5. Replies
    9
    Views
    534

    This is a 2001. I owned a 99 model 90ELPTO a few...

    This is a 2001. I owned a 99 model 90ELPTO a few years back and it beeped when key was turned to on. It’s also referenced in the owners manual.
  6. Replies
    9
    Views
    534

    MERCURY ENGINE WARNING SYSTEM PROBLEM

    I’ve got a 90hp 2 cycle Mercury on my H-51 Alumaweld with a Merc Commander 2000 remote control. When the key is turned to the ON position there should be a momentary beep signaling the warning system...
  7. Replies
    7
    Views
    567

    Thanks to all for your comments - I’ll be buying...

    Thanks to all for your comments - I’ll be buying the right sized breaker. I’ve seen how quickly a shorted 12V battery can start a fire.
  8. Slow hand salute

    Slow hand salute
  9. Replies
    0
    Views
    419

    WTB Alumaweld H51 windshield

    Refurbishing a 1995 Alaumaweld H51 and need a windshield. Any condition considered even in pieces so long as it's all there.
  10. Replies
    7
    Views
    567

    Trolling Motor Fused?

    I'm refurbishing a 1995 Alumaweld H51 that came with a 12V Terrova trolling motor. While tracing the wiring I see no fuse for the trolling motor. I appears the cables run directly to the motor from...
  11. Replies
    9
    Views
    606

    Don’t trust the adhesive strip that is used on...

    Don’t trust the adhesive strip that is used on most strip lights. No matter how well you prepare the mounting surface they’ll fail soon. Use the 3M VHB as suggested by others.
  12. Replies
    1,942
    Views
    212,080

    Sticky: Air Force 1967-71, 1st Mobile Comm Group,...

    Air Force 1967-71, 1st Mobile Comm Group, Philippines, Taiwan, Guam, Okinawa, Vietnam, Laos, Cambodia
  13. Replies
    18
    Views
    724

    If you’re going to open up the remote to replace...

    If you’re going to open up the remote to replace the neutral lock I’ve got some suggestions based on my experience with them: 1) take photos as you disassemble 2) replace the neutral safety switch...
  14. Replies
    12
    Views
    1,972

    My last one was an Atwood and I like the...

    My last one was an Atwood and I like the swiveling pads much better than the rubber V on the Extreme the square tubing on the Atwood was split at every corner.
  15. Replies
    12
    Views
    1,972

    MOTOR TURNING WHILE TRAILERING

    Not sure if this is a transom saver or motor issue but while towing my Alumaweld H51 with 90hp Merc and using an Extreme Max 3001 transom saver my motor moves/flops from to one side to the other when...
  16. 304 stainless machine screws sized 10-32 with...

    304 stainless machine screws sized 10-32 with locking nuts
  17. Replies
    26
    Views
    35,735

    Sticky: Anyone know where I could find graphic files (any...

    Anyone know where I could find graphic files (any format) or actual decals for 94 or earlier Alumaweld logos and side stripes?
  18. Replies
    26
    Views
    35,735

    Sticky: Want to buy a windshield for a 1994...

    Want to buy a windshield for a 1994 Alumaweld/XPress H-51 — any condition. If I can’t polish it out or glue it together I’ll use it as a template.
Results 1 to 18 of 18