Search:

Type: Posts; User: Bplank79

Search: Search took 0.00 seconds.

  1. That is the Livewell Switch. The position it is...

    That is the Livewell Switch. The position it is in now is empty, or open.
  2. Replies
    4
    Views
    213

    I have a 1 Bank and a 3 Bank mounted vertically...

    I have a 1 Bank and a 3 Bank mounted vertically in the left rear of my 210 Super Pro.

    495633495634
  3. Replies
    3
    Views
    294

    In WI & MN we have 91 Octane Recreational or...

    In WI & MN we have 91 Octane Recreational or Non-Oxygenated "Ethanol Free" fuel.
    I downloaded and use the "Pure Gas" app on my smartphone to find stations with these fuels.

    486931
  4. Replies
    4
    Views
    419

    I replaced my two timers with these 3 Pin Timers....

    I replaced my two timers with these 3 Pin Timers. Snapped right into the connector.

    3 Pin Timer Pod Only | iBoats
  5. Replies
    5
    Views
    521

    How to measure the distance from the pad to prop shaft

    460568
  6. Replies
    3
    Views
    391

    :nanner:Shout out to MNbassfisning11 who had the...

    :nanner:Shout out to MNbassfisning11 who had the exact part I was looking for and was willing to part with it.
  7. Replies
    3
    Views
    391

    Thank you for the reference.

    Thank you for the reference.
  8. Replies
    3
    Views
    391

    Wanted - Passenger Side Rod Holder

    Does anyone know where I can find this Rod Holder (receptacle) for the passenger side?

    458039
  9. Replies
    9
    Views
    935

    We did not. But we will now. Thanks Don!

    We did not. But we will now.

    Thanks Don!
  10. Replies
    9
    Views
    935

    UPDATE to close this thread.

    After a water test now that the ice is out here, the issue appears to be resolved.
    We found oil in the fuel tank, lines and primer bulb. Replaced the Oil Injection Check Valve #28 in the photos...
  11. Replies
    31
    Views
    23,258

    I would love to see pictures as well for my XB.

    I would love to see pictures as well for my XB.
  12. Thread: Recess Tray

    by Bplank79
    Replies
    7
    Views
    571

    I installed a Panther MarineTech Trolling Motor...

    I installed a Panther MarineTech Trolling Motor Foot Control Tray in my 2000 210 Super Pro DC.
  13. Replies
    9
    Views
    935

    Cleaned fuel pump and installed a new diaphragm...

    Cleaned fuel pump and installed a new diaphragm kit. Pulled carbs apart again, no debris or blockage found. Fuel line is new. Switched anti-syphon valve out with one from a new tank. Starts fine,...
  14. Replies
    9
    Views
    935

    Thanks Joe. Disassembled and cleaned all 3 carbs,...

    Thanks Joe. Disassembled and cleaned all 3 carbs, replaced the fuel filter and the primer bulb, and fuel is fresh. We now have 3 cylinders running at idle, and seems to pull well at low end, but the...
  15. Replies
    9
    Views
    935

    1998 90 ELPTO running on 2 Cylinders

    1998 90 ELPTO S/N 0G723073 idles, lacks power and bogs out past 1/2 throttle. Pulled each plug wire one at a time and with another spark plug grounded to the motor, the bottom and middle cylinders...
  16. Thread: 250 pro xb

    by Bplank79
    Replies
    8
    Views
    579

    Where can ACES be purchased?

    Where can ACES be purchased?
  17. Replies
    1
    Views
    297

    404035

    404035
  18. Replies
    13
    Views
    2,739

    I have a Fortrex 112 lb. 36V on my 2000 210 SP...

    I have a Fortrex 112 lb. 36V on my 2000 210 SP DC. I have (4) 27 series batteries positioned in the center section rear storage compartment. The battery charger is in the port rear compartment and...
Results 1 to 18 of 18