Search:

Type: Posts; User: jab0106

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: Merc P2P

    by jab0106
    Replies
    3
    Views
    128

    Went yesterday and ran the tempest+ 24 at 3.75...

    Went yesterday and ran the tempest+ 24 at 3.75 and 3.5, turned 6050 72.5gps and 6170 73.5gps respectively, still pegging my psi so probably have some more raising available. Ride improvement...
  2. Thread: Merc P2P

    by jab0106
    Replies
    3
    Views
    128

    Merc P2P

    Running a 23p Fury3 at 3.75", curious at what P2P I should expect to run a Fury4, a Tempest Plus, and a Bravo 1 XS.

    Motor is a 225 Merc FS, currently turning 5900 on the best days, 71-73gps. ...
  3. Replies
    6
    Views
    395

    Just trying to limp home and even the idle has a...

    Just trying to limp home and even the idle has a whole boat shake now, went to check prop again and half of a blade is gone. Guess that’s that.
  4. Replies
    6
    Views
    395

    225 proxs fs vibration

    On the water currently and after a run and set down to idle by a vessel motor has picked up an odd growling vibration with less power and has me leery to even put on plane. Anything I can check or...
  5. Replies
    9
    Views
    275

    520330Right now I’m thinking its usable, was...

    520330Right now I’m thinking its usable, was looking a drop in quick swap of the kit and lead wires but seems like the shortest prefab leads are 54.5”, 55”, 56.5”, are these just for preference of...
  6. Replies
    1
    Views
    138

    Older 17.5 w a 40hp reprop

    Used to run 32 only getting about 26-27 now with the prop blades all mangled up from hard use in skinny waters. Looking to reproduce. It I have never been able to find anything stamped on either...
  7. Replies
    9
    Views
    275

    Hot to brush plate burned up, corroded bad, blade...

    Hot to brush plate burned up, corroded bad, blade and brush blackened and boogered. Will get a brush kit and redo the hot.
  8. Replies
    9
    Views
    275

    Have 38v power out the controller in the foot...

    Have 38v power out the controller in the foot pedal. Opened the head and found the shaft brown wire fuse 3amp blown and also the wire pinched , will resolve those but jumpering that did not change...
  9. Replies
    9
    Views
    275

    I will do that thanks guys

    I will do that thanks guys
  10. Replies
    9
    Views
    275

    Fortrex 112 doing nothing

    In a cold wet tournament got hung in some shallows with cypress knees and early pads, gave it the blues getting unhung but immediately after motor just quit. No sound no movement momentary nor...
  11. Replies
    23
    Views
    1,476

    I will have to test mine more on boat wakes but...

    I will have to test mine more on boat wakes but it currently handles the wind chops pretty well, but there is definitely more side to side play when decelerating than in times past. This thing used...
  12. Replies
    23
    Views
    1,476

    early on I hooked the bow a couple times when not...

    early on I hooked the bow a couple times when not properly turning as the 2s always kept a lot of boat in the water anyhow, just needed to get the bow down before the turns as I head up the...
  13. Replies
    23
    Views
    1,476

    I had some play in the connection between the...

    I had some play in the connection between the hydraulic cylinder and motor Mount, the hotfoot was adjusted to allow more travel toward the driver.
  14. Replies
    23
    Views
    1,476

    Old thread, new info, looking more. got my...

    Old thread, new info, looking more.

    got my throttle adjusted, was only seeing 94%. Now at 100%. Also the steering jam nut got tightened 3/4 turn.

    run- 55* water 50* air 3.5 p2p max 6000 rpm...
  15. Replies
    9
    Views
    248

    Best I can tell all I have is the breaker in the...

    Best I can tell all I have is the breaker in the bilge, the brain box, and then keypad. For whatever reason on my last attempt at this worked out, seemingly from a third reset of the breaker. Think...
  16. Replies
    9
    Views
    248

    Alpha 199 wiring

    Where are all the fuses for things such as keypad bilge livewell etc

    i have an Hds wouldn’t power up, found bad ground I am trying to repair but when I thought I was done the keypad no longer...
  17. Thread: Stablecoin

    by jab0106
    Replies
    7
    Views
    466

    20% on my ust looked good for a while, but I’m...

    20% on my ust looked good for a while, but I’m not foolish enough to jump head first at least
  18. Thread: Stablecoin

    by jab0106
    Replies
    7
    Views
    466

    Hit me for a bit

    Hit me for a bit
  19. Replies
    13
    Views
    959

    Booyah double willow large gold small silver...

    Booyah double willow large gold small silver white 1/2 oz, it’s solid everywhere. Draws bites tracks true bangs rocks rips grass doesn’t catch a ton of snot and rarely need to retie or reblade...
  20. Replies
    23
    Views
    1,476

    Let me know what you see. I’m having trouble...

    Let me know what you see. I’m having trouble locating a 23 tempest local to test. Last trip was Saturday and average loaded, full gas, was seeing 72+ gps and 6000 rpm, after livewell fill it was...
  21. Replies
    5
    Views
    387

    still have the divider just doesn’t sit tight any...

    still have the divider just doesn’t sit tight any more a hard fish tail kick will knock it out of place currently

    Bow panels I mean the plastic that the trolling plug, 12v outlet, and trim switch...
  22. Replies
    5
    Views
    387

    this is the route I was think of going

    this is the route I was think of going
  23. Replies
    80
    Views
    4,562

    There’s a difference in fished to death and...

    There’s a difference in fished to death and fished ever
  24. Replies
    6
    Views
    250

    any difference in 2991754 and 2991755? part...

    any difference in 2991754 and 2991755? part reference for mine is the 55.
  25. Replies
    5
    Views
    387

    Alpha 199 minor maintenance

    Where can We get replacement parts? I need to get the bow panels to replace my current ones, I’ve cracked one.

    Any idea a best method how to reinstall livewell divider? The gap seems fairly...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4