Thanks I'll look into getting a manuel. The motor has very few hours on a new powerhead. Powerhead was done about 10 years ago and had 10 hours on it before I got it. I ntry it!
Type: Posts; User: mako221
Thanks I'll look into getting a manuel. The motor has very few hours on a new powerhead. Powerhead was done about 10 years ago and had 10 hours on it before I got it. I ntry it!
Thanks for the reply. I basically do as you say on start up. I forgot to mention above that motor starts and runs 100% better on flushers opposed to being the water.
Does a Manuel tell one how to do...
1 issue happened briefly last season. started motor and could not get max rpms. about 1000 under max (5600) took it out to show guy problem and it did not happen, obtained max rpms rest of season....
Does it matter what unit you enter/load waypoints routes and trails into? Should I use exclusively one unit or the other, if so why?
Thanks
I transferred via SD card a Region of Waypoints, Routes & Trails from Hook to Live Unit.
In this region I will add to existing trails by activating the record feature. If I save this region...
No debris in thermostats
if it acts up this weekend, I’ll have poppet checked.
Seriel # 2B361560
this weekend operating in 50 degree water, I had 2 thermostat warning alarm out of numerous starts.
I noticed it seemed to take too long to reach 100 degrees.
when it hit a 100...
I am on third compressor at 1450 hours. Both times compressor locked up and stopped motor, both times motor was idling or very close to it. I am sure fuel rails and injectors were not cleaned,...
Will replace with installation of new 2016 225 pro xs. Placing order tomorrow
Took boat to dealer and he diagnosed the problem as a vibration of the triangle plate above the steering tube. since it is a sporadic occurrence, i can live with it until time to replace steering...
Yea I hear ya. Will keep ya posted.
Love BBC boards, been checking in for at least 10 years.
Hello
Took lower cowlings off and no visible signs of wear..
I don't believe this is a rattling noise. This past weekend in the morning I was not able to get the motor to make the noise until...
Boat 22' Center Console - WO RPM 5800, Prop stainless inertia Not sure of pitch, Smart Craft Gauges, Sorry don't have serial# with me now. Owned motor since new.
Noticed that when I am running...
Thanks will update.
The prop is not ventilting. When I say wave it is not a significant wave just enough to bump nothing even close to be to ventilate the prop which I have done many a time running in the ocean. This...
bump
Noticed a couple a weeks ago that when I was running along and would hit a wave the RPMS would jump up a couple 100. I would just pull back throttle a bit real quick. Then I noticed if I did note...
Hello I am taking it to shop this am. Could it be a bad coil? After reading more on this board it acted like a coil are at least some interuption of spark. Thanks for your help.
Was fishing for 4 hours today. Motor ran fine until I went to come home. Before I got on plane it sounded like it was missing. I put it plane and it would only turn 4800 and then it would jump up to...
Was fishing for 4 hours today. Motor ran fine until I went to come home. Before I got on plane it sounded like it was missing. I put it plane and it would only turn 4800 and then it would jump up to...