Prayers everything works out.
Type: Posts; User: sfstorm
Prayers everything works out.
Isn't the L2 Lightning the one they were having problems with on the 250ho so they went to the M2. I am hoping with a nose cone and low water pickup to be able to regain some of the lost performance...
mactlman thanks for the feedback, I will ask over there as well thank you.
Thanks for the info, I am putting the 250 ho on a Allison XB21. My old motor was a 225 and I was running a 26 raker. someone told me that the older lower unit was a lower gear ratio and that i would...
I have a 2014 Evinrude 250HO etec Model# E250HGLABB, Serial#5414726 with the M2 gear case and was wondering what the gear ratio is.
Will this lower unit require a bigger pitch or small pitch prop...
Thank you very much Tim Powell, that is the exact information I was looking for. I was really worried about running screws through the bottom of the boat but now I feel more confident that I won't...
The batteries are group 29 deep cycle lead acid.
PSM207 that is good idea, do you have any problems with the batteries moving around in rough water, not that i go out when it's rough just curious. Every once and a while Lake Okeechobee can get...
I have a question so I don't mess up really bad. I have a 2003 XB21 2+2 and i'm moving my 2 troll motor batteries to the left side rear compartment. Do I put them to the back or front in the...
Sorry about that, it is a 2014 Evinrude ETEC 250 h.o.
:praying::praying:
Can anyone tell me what Gauges they are using now in the XB-21 2+2, I want to replace my gauges in my 2003 XB-21 and was looking for some options what people are using.
Thanks
Thanks for all the info guy's, i need to move my other troll motor battery into the port compartment and I should be pretty good. What would be the best hold down for the troll motor batteries and...
Well that's cool red rocket, I know there are a handful of Allison's down here is south Florida but I would have never guessed one in Loxahatchee. Most people never even heard of this place LOL. I...
I have a 2003 Allison XB21 2+2 Bassport Tournament Elite with a 24 V troll motor. I was wondering what is the best placement of the 2 troll motor batteries, Crank battery and the 3 gallon oil tank....
Sorry for your loss to the both of you. Prayers lifted..
Happy Birthday Tim.
I have a gear case off of my 2000 Johnson 225 that has the nose cone and low water pickup installed by Bob's, will this case bolt up to the new engine with the new style water pump installed.
I thought I would post this here since there is more traffic to see the post and possibly get some suggestions and input.
I have a 2014 Evinrude etec 250 HO that is going on a 2003 Allison XB21...
So sorry for your loss.
Thanks for the reply, I have my old gear case from my 2000 Johnson 225 that already has all the performance mods done (nose cone, low water pickup ect.) I will probably just stick with that case then.
I have a 2014 Evinrude 250 HO (new to me) and was wondering if anyone has had any luck regaining the lost performance of the M2 gear case by running a nose cone and low water pickup. I have heard...
What would have been really funny is if they glued themselves to the runway and then found out it was already closed for repairs, then they just leave them there until they figure out how to get...
If you have any questions I might be able to help you with let me know.
I have a 2003 XB21 2+2 Bassport, tandem axle trailer, no swing away tongue, motor trimmed down, 8 inch set back on motor and i am at 25 feet give or take an inch.