Thank you Leon,I will do that. Joe said max .020"
Type: Posts; User: pchristensen
Thank you Leon,I will do that. Joe said max .020"
I have been looking up reed stuff here and found a post by Don about the flywheel cover being damaged, well mine has a big rub hole through it from the alternator. Does this mean I need to replace...
Some of the reeds have gaps, is there a spec for the gap using a feeler gauge ?
1995 Mercury 225 3.0 carb serial #0g178560
Was going to replace reeds with carbon fiber and found these already in engine. Any idea of brand and if they are good ? Thanks in advance!
Thank you
Thank you
Thanks Don
Thank you
Hello all, I really appreciate this site and all the help I have received in the past. I just purchased a 1995 Champion 202 with a 1995 Mercury 225 carb motor and I am going to pull the motor to...
Hello all, I really appreciate this site and all the help I have received in the past. I just purchased a 1995 Champion 202 with a 1995 Mercury 225 carb motor and I am going to pull the motor to...
Thanks Don
I am looking to buy a 1995 Champion 202 with this engine and have no idea of pros and cons, any input greatly appreciated !
You are right again Joe, cannon plug had very loose pins. I tightened these using a procedure Don posted previously in another post by using a razor knife to expand pins to fit tighter. Also had a...
Hi Joe, are you talking about the big harness connector (8 pin) under cowl and the big fuse with red wire?. Thanks again !
Serial #0a137330 1985 Mariner 2.4 175 hp
Well I made it a little while before new issues. Rebuilt power head, carbs, new trigger, stater, rectifier a few months ago. Took it out the other day and...
Well I had a chance to take boat out today and it started and ran with no issues, idles and accelerates good. Only thing I noticed that was different now is my temp gauge goes down to cold after...
Thanks for the help Joe, a buddy at work loaned me a flywheel holder and I got the crank nut torqued. He also loaned me a Snap on timing light that has a tach that is much like mine. His light also...
Ok good news it was the timing light, borrowed a buddies from work and strobe was consistent. Removed idle box and set idle timing to 4 degrees atdc and wot timing to 20 degrees btdc. Will just need...
That would be nice. I’m trying another light tomorrow. Thanks
Thanks Joe I will set it running then see if I can set wot timing not running after warm up. It had a stalling problem before I took powerhead apart. I replaced trigger but I have a feeling I have a...
I am running a 100 to 1 in the tank plus the oil injection for break in. I was trying to check the timing on a dead cold engine and my plugs are very wet, will this cause a no spark or should my...
serial #0a137330
1985 Mariner 2.4 175 hp
Hoping someone can please help me out again. I got my engine all back together and it was a little hard to start but does run and hasn't died on the...
Thanks again Joe, just what I wanted to hear, This motor already drinks enough fuel !
serial number 0a137330
1985 2.4 175 hp Mariner
The carbs are marked wh-30 and have 4 .064 and 2 .066 main jets. All idle jets are .070 and all vent jets are missing. Carbs might not be original...
Thanks Joe you and Don have been a huge help in the assembly of my engine.