Thanks Scott.
http://img37.imagevenue.com/loc1104/...122_1104lo.JPG
Printable View
Thanks Scott.
http://img37.imagevenue.com/loc1104/...122_1104lo.JPG
Here's a slightly better to read version I typed up.
http://img.photobucket.com/albums/v6...ringColors.jpg
Thanks Mark.
Will these work on a 896dc
Are these the same codes for a 1998 Nitro 700LX?
this is helpful for down the road. Thanks mark
one would hope they do this the same on all boats.
Thanks friend!
Mike
Thanks for the help. We'll see how this works.
I have a 90 nitro ... Is this the wiring code??
Just installed a radio in my 2012 Z-8 fuze labled constant hot is not infact checked main power to the fuse box and it goes dead when I turn off the Acc switch is this normal?
Sent you a pm
Looking to add a trim switch to the steering wheel.....where would this be noted on the thread above?
I have a 2011 Z8 and digging into the bow wiring, I find two sets of wires that look the same, and one is wired to the factory depth finder. Being simple minded as I am I suspect they provide for two locators?
I have a '15 Z9 that I am putting Blue Waters on - is the wiring code posted here valid still? All lights are in place I just want to make sure that I tap into the right power.
Any help would be appreciated!
C4F
C4F,
When I did the Bluewaters on mine, I ran all the wires for all the lights and used the Courtesy light in the bilge as the power source. This allows me to turn them on with the touchpad.
http://www.bbcboards.net/boat-traile...intensive.html
Hey, guys.. I just signed up for this, due to me being a new, first time, boat owner.. could anyone here help with some question I have about an 2004 nitro 901 cdx?
Can we get a trailer wire diagram explaing what wire is what
The trim down switch on my 2006 Nitro 482 will not work.. Trim down works fine. Trim up/down work just fine on motor and throttle handle. I tested the bow switch by swapping wire sets on up/down and the down works but still not up. Is there a fuse or most likely a broken wire somewhere?