Finally upgraded my bow electronics with a Lowrance Elite 7x, my console with Lowrance HDS 9 touch, and some Bluewater LEDs for "BLING"
Printable View
Finally upgraded my bow electronics with a Lowrance Elite 7x, my console with Lowrance HDS 9 touch, and some Bluewater LEDs for "BLING"
Sweet! Love the led`s!
Mark where did you get the lettering for your name done?
new tool holder
Put some blue waters on her tonight, I'll see what she looks like in the water Sunday!
Thats cool! where did you mount it? is it a led strip?
I went with the 4 light block style blue waters they came in a two pack I stacked them one at the top and one at the bottom so the water gets a good red glow.
I can send pics with lights off if you want.
Just made an updated flush mount bezel for an HDS-9 on the bow of my 619 since the "9" won't fit into the stock location. It's made from scratch using mostly fiberglass and a lot of
hand-shaping. I wrapped it in marine grade vinyl that matches the stock bow shroud. I molded in a 3/16" gap all the way around the unit to allow the cover to fit in nice and snug and the gap is sealed from water getting in by using foam gasket tape under the bottom edge of the unit. The bezel is mounted to the stock bow shroud via stainless screws through the backside and is sealed with a small bead of silicone. The HDS-9 is used for mapping only alongside the HDS-12 on a RMC E-lok mount on the bow as well.
A few more shots.
That's some real quality work Rise! Well done.
Agreed! Looks great Greg!
Thank you very much guys. Appreciate the kind words.
https://www.facebook.com/FreedomMarineCenterThis is one of our customer's boats that we installed a complete blue water LED system on. Check it out at Freedom Marine Center Facebook page.
https://fbcdn-sphotos-f-a.akamaihd.n...5d76bc88d26b33
https://fbcdn-sphotos-g-a.akamaihd.n...f5501939102db4
Ok Phoenix junkies here is the dimensions for the tackle storage. All bin walls and shelf is 5" inches in width. Shelf face is 2 3/4" inches tall. Material is 1/2" inch King starboard. All top edges have been radius 1/8" inch. Note: 6 5/8 bin walls have a 2-3 degree angle were they meet the compartment outside walls. If you make one of these or something like it please post it here on the boards for all of us to enjoy. Thanks!
Attachment 141359
Rise does that put your graph at more of a angle so you can see it better.
Thanks for the idea, I changed mine up some. I used PVC board from lowes it's only 3 1/2" x 3/4".
I gotta tell you guys that storage compartment mod is sweet!! Phoenix should sell that as an upgrade. I will be adding that to mine for sure. Nice job guys!!!!!