Originally Posted by
r82ranger
Have a brand new boat, power pole mounted to jack plate on side where the motor mounts in the bracket. The bracket slid down and damaged my fiberglass sponson. On closer inspection the motor on that side dropped in the jack plate. I had to loosen the bolts and jack the motor back into place and re tighten the bolts. This seems like a bad design to me there is only a slot for mounting no round hole to hold bolt and motor in place. I am disappointed as it came rigged from the dealer that way seems to me the bolts were not tightened properly or worse this will continue to happen. I have purchased a 3/4 socket and 18 inch 1/2 inch drive arm and tighten the bolts now after each trip and check them again after arriving home.
any one else have this problem??
FX20 skeeter slidemaster jack plate